Skip to content
SearchFree account
Menu
Article

Diesel particulate filter full: what the light means and what to do

The particulate filter of your diesel cleans itself while you drive. With many short trips that does not work. This is how you help the filter and which code goes with it.

Published on 15 November 20263 minute read

In short

  • The traps soot and burns it off at a high temperature. With many short trips or low speeds that does not work.
  • If the light comes on, a longer drive usually helps. How exactly is in your owner's manual.
  • If the light stays on or flashes, have the car checked. Driving on can damage the filter.

Why the filter fills up

The () is not a filter you replace. It burns off the soot itself when the exhaust gases are hot enough, during normal or fast driving. This is called regeneration.

If you mostly drive short distances or slowly for a long time, the exhaust gases stay too cold. The soot builds up and a light comes on.

Light on: what to do

  1. Look in your owner's manual for the drive your car needs.
  2. An example from one manufacturer: drive faster than 60 km/h, or for about 25 minutes in a gear higher than second, at 1,500 to 2,500 rpm. Always within the speed limit.
  3. Does the light stay on or flash, or do you see a message about the exhaust system? Have the car checked. Driving on can damage the filter, use more fuel and dilute the oil.

The fault codes

A code says what the car measures, not which part is broken. The cause can also be in the engine; the garage finds that out. A few codes that belong to the :

  • P2463: too much soot in the filter.
  • P242F: too much ash in the filter.
  • P2002: the filter works less well than it should.
  • P2452: fault in the filter's pressure sensor.

The particulate filter at the roadworthiness test

  • Netherlands: since 1 January 2023 the periodic test () counts the particles on diesels with a . At idle there may be no more than 1,000,000 per cubic centimetre. If your car should have a and it is no longer there, it fails.
  • Belgium: since 1 July 2022 the inspection counts the particles on diesels from Euro 5. Between 250,000 and 1 million you get a remark. From 1 million you get at most 6 months to repair.
  • Germany: since 1 July 2023 the emissions test (AU) counts the particles on diesels from .

What Car-Z does and does not see

  • Free: the of the , with an explanation.
  • With Plus: whether the of the is complete (), and the results per , if your car reports them.
  • Not: how full the filter is and whether it is regenerating now. Car-Z does not start a regeneration either: the app only reads.

Frequently asked questions

How do I clean my particulate filter?

Usually with a longer drive, as your owner's manual describes. If the light does not go off, have the garage look at it.

Can Car-Z start a regeneration?

No. The app only reads.

I have code P2002. Does the filter need replacing?

Not necessarily. The code says the filter works less well than it should. The cause can also be in the engine. Let the garage find out.

Sources

  1. Emissieregelsysteem (roetfilter), instructieboekjeKia, consulted on 15 November 2026
  2. Waarschuwingslampjes (uitlaatsysteem, DPF), instructieboekjeKia, consulted on 15 November 2026
  3. APK-handboek personenauto's, Geluid en milieu (artikel 45e)RDW (Netherlands), consulted on 15 November 2026
  4. Dieselvoertuigen (ontwikkeling 2 en 3: roetfilter en deeltjesteller)RDW (Netherlands), consulted on 15 November 2026
  5. Roetfilter en deeltjestellertestFlemish government (Belgium), consulted on 15 November 2026
  6. Einführung der Messung der PartikelanzahlkonzentrationFederal Ministry of Transport (Germany), consulted on 15 November 2026

Read it yourself with Car-Z

Put a plug into the OBD port and see on your device what the car itself reports. Testing whether your plug and car work and reading the fault codes is free, without an account.

All articles