ABS and stability control may be switched off. Your normal brakes still work, but wheels can lock in an emergency stop. Keep extra distance, especially on wet or slippery roads.
What does it mean?
Each wheel has a sensor that measures how fast it turns. ABS, traction control and stability control depend on these signals. The signal of the sensor left rear is not right. The control unit sees an electrical fault in this circuit. Most often that is a broken wire, a corroded or loose plug, or a defective part. Chassis codes are often used differently by each manufacturer, so have the exact meaning checked for your brand.
This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.
What you may notice
- ABS, traction control or stability control light on
- ABS pulses at low speed even though the road is not slippery
- Speedometer or cruise control does not work on some cars
Common causes
- Dirt or rust between the sensor and the reluctor ring
- Damaged sensor cable, often near the wheel arch
- Defective sensor
- Damaged reluctor ring or wheel bearing
What you can check yourself
- Look at the cable from the sensor at that wheel: is it intact and not chafed?
- Note whether the problem started after work on the brakes, suspension or wheel bearing
What to ask the garage
- Is it the sensor, the cable or the reluctor ring?
- Is the wheel bearing OK?
Checked on 14 November 2026