Skip to content
SearchFree account
Menu
Fault codes and inspection

Clearing fault codes safely

Clearing switches off the light, but fixes nothing. It also restarts the readiness self-tests and removes the freeze frame from the car. Read this before you clear.

3 min readUpdated 15 November 2026

What clearing does and does not do

Car-Z only clears engine and emission codes through standard . It does not clear codes from , airbags or other safety systems; for those you go to a garage.

  • Stored and are cleared and the goes out.
  • Clearing does not fix anything. If there is a real fault, the code comes back and the light goes on again.
  • The () start again from zero. It usually takes a few days of normal driving before they are ready.
  • The disappears from the car. Car-Z first keeps it in a on your device.
  • stay. The car removes those itself once it has checked the system again.

Before a roadworthiness test or a sale

In many countries the periodic test (such as the , HU/AU, contrôle technique, ITV or ) reads the car's system. If too many are "not ready", the car can fail or the test cannot be finished.

When clearing makes sense

  • After a repair, to see whether the fault stays away.
  • After a one-off cause has been fixed, such as a fuel cap that was not closed properly.
  • Not to hide a fault: a garage, inspector or buyer can see that codes were cleared recently.

Step by step in Car-Z

Can you not tap the button? The screen tells you why, for example because the engine is running or the car is moving. Clearing only works with the car standing still, the ignition on and the engine off.

On some newer cars a blocks clearing with an ordinary . Car-Z then says that clearing failed. On the page of your make you can see whether that applies to your car.

  1. Park the car. Switch the ignition on and leave the engine off.
  2. Under "", tap "Clear codes".
  3. Step 1 of 2: read the risks and tap "Next".
  4. Step 2 of 2: check which codes will be cleared, and tick "I have read the risks and accept them".
  5. If you like, add a reason, for example "replaced a bulb". It stays on your device with the .
  6. Tap "Clear codes". Car-Z saves the first; if that fails, nothing is cleared.

Afterwards

Read the codes again after a few trips. If a code you cleared comes back, Car-Z shows "Came back after clearing" with that code. Then something is probably really wrong: have it checked.

Car-Z never clears codes by itself. It only happens when you tap the button.

Was this guide helpful?

Your answer is only saved on this device.

Ready to read your car?

Plug in your dongle, switch on the ignition and open the app.

All guides