What does it mean?
An oxygen sensor only works when it is hot. A built-in heater makes sure it is ready soon after a cold start. The control unit sees an electrical fault in that heater or its control. Sensor 1 sits before the catalytic converter, on the side of the engine with cylinder 1 (bank 1).
This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.
What you may notice
- Engine warning light on
- Slightly higher consumption just after a cold start
- Usually nothing noticeable while driving
Common causes
- Burnt-out heater inside the sensor (the sensor is then replaced as a whole)
- Blown fuse for the sensor heaters
- Damaged wiring or a melted plug near the exhaust
What you can check yourself
- Check the fuse for the oxygen sensor heaters (see the owner's manual)
- Look for melted or chafed wires near the exhaust
What to ask the garage
- Was the resistance of the heater measured?
- Is it the sensor, the fuse or the wiring?
Checked on 14 November 2026