Skip to content
SearchFree account
Menu
Powertrain · Fuel and mixture

P0628Fuel pump control: signal too low

Important

If the pump stops working, the engine stops. If the car starts poorly or stalls, don't drive far from home.

What does it mean?

The fuel pump in the tank is switched on by a relay or controlled by its own module. The sees an electrical problem in that control. The voltage is lower than a working part can deliver. Usually that points to a short circuit to ground, a broken supply wire or a defective part.

This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.

What you may notice

  • on
  • Hard starting or long cranking
  • Engine stalls or hesitates under load
  • Sometimes no start at all

Common causes

  • Defective fuel pump relay or fuse
  • Corroded plug on the tank or the pump module
  • Damaged wiring, often under the car
  • Worn fuel pump that draws too much current

What you can check yourself

  • Turn the ignition on and listen for the fuel pump humming for a few seconds
  • Check the fuse for the fuel pump (see the owner's manual)

What to ask the garage

  • Is it the relay, the wiring or the pump?
  • Was the current draw of the pump measured?

Checked on 14 November 2026

Read the codes of your own car

Put a small plug into your car and open Car-Z. You will see all stored codes with this explanation, plus live data.

All fault codes