Skip to content
SearchFree account
Menu
Powertrain · Diesel, particulate filter and AdBlue

P2463Diesel particulate filter: too much soot

Important

A very full filter can make a regeneration too hot. Don't ignore the warning light, and don't just keep doing short trips. If the car is in emergency mode, go to a garage.

What does it mean?

The () catches soot from the exhaust gas. The filter is fuller with soot than it should be. Normally it burns the soot off by itself during longer drives (regeneration), but that has not happened often enough.

This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.

What you may notice

  • warning light or on
  • Less power or emergency mode
  • Higher fuel consumption
  • Cooling fan keeps running after you switch off (regeneration interrupted)

Common causes

  • Many short trips, so regeneration does not get a chance
  • Faulty pressure sensor that misjudges the load
  • Engine problems that make extra soot, such as a defective or injector
  • Wrong engine oil (not low-ash) or high oil consumption

What you can check yourself

  • If the car is not in emergency mode: a drive of 20 to 30 minutes at a steady speed on the motorway often helps the filter clean itself
  • Check that you use the engine oil your car prescribes

What to ask the garage

  • How full is the filter according to the measured values?
  • Can a forced regeneration be done in the workshop?
  • Is there a cause of extra soot that needs fixing first?

Checked on 14 November 2026

Read the codes of your own car

Put a small plug into your car and open Car-Z. You will see all stored codes with this explanation, plus live data.

All fault codes