What does it mean?
EPC stands for Electronic Power Control. Volkswagen, Audi, SEAT, Cupra and Škoda use it for faults in the electronic throttle and the parts around it, such as the accelerator pedal sensor, the throttle body or the brake light switch.
When the light is on, the engine often runs in an emergency mode (limp mode): less power, sometimes a fixed engine speed. Usually the engine warning light comes on as well.
The light coming on for a few seconds after you switch on the ignition is normal: that is the bulb check.
What can you do?
- Drive calmly and avoid overtaking and other moments where you need full power. With a strong loss of power, stop as soon as it is safe.
- Ask someone to check your brake lights: a faulty brake light switch is a known cause.
- Have the fault code read out soon.
What can Car-Z do with it?
Car-Z can read thisYes. EPC faults are almost always stored as an engine fault code, for example for the throttle body or the accelerator pedal (P0121, P2135) or the brake pedal switch (P0571). Car-Z reads and explains them.
Related fault codes
These codes are stored by the car when it finds the fault behind this light, as far as the car reports them over OBD2.
- P0121Throttle position sensor A: signal out of the expected rangePlan a garage visit
- P0122Throttle position sensor A: signal too lowPlan a garage visit
- P0221Throttle position sensor B: signal out of the expected rangePlan a garage visit
- P2135Throttle sensors A/B disagreePlan a garage visit
- P2101Electronic throttle: motor circuit out of rangePlan a garage visit
- P0571Brake pedal switch: switch A circuit faultPlan a garage visit
This page is an indication, not safety advice. Symbols, colours and the meaning differ per make and model: always check the owner's manual of your car. When in doubt, contact a garage or roadside assistance.
Content checked on 14 November 2026.