What does it mean?
Many modern diesels inject AdBlue, a urea solution, into the exhaust to turn harmful NOx into nitrogen and water. The car warns well in advance when the tank gets low, usually with a remaining range.
Because of the emission rules the car must not run without AdBlue. When the tank is empty, or the system has a fault for too long, the engine will not restart once you switch it off. The countdown is shown on the dashboard.
A fault in the system (pump, heater, dosing valve, NOx sensor) can show the same light, often with a message. Topping up does not help then.
What can you do?
- Top up with AdBlue (ISO 22241) through the separate filler, usually next to the diesel filler or under the bonnet. Never put AdBlue in the fuel tank or diesel in the AdBlue tank.
- After topping up, some cars need a short wait or a drive before the warning disappears; check your owner's manual.
- Message about a fault in the system: have it read out by a garage before the countdown runs out.
What can Car-Z do with it?
Car-Z can read part of thisPartly. Car-Z reads fault codes of the AdBlue system and the NOx sensors (such as P20EE and P203F) and explains them. The AdBlue level and the countdown are brand-specific and usually not available over standard OBD2.
Related fault codes
These codes are stored by the car when it finds the fault behind this light, as far as the car reports them over OBD2.
- P20EENOx catalytic converter (SCR) efficiency too low, bank 1Plan a garage visit
- P20E8AdBlue system: pressure too lowPlan a garage visit
- P203FAdBlue level too lowPlan a garage visit
- P20B9AdBlue system: heater circuit faultPlan a garage visit
- P2047AdBlue system: dosing valve circuit faultPlan a garage visit
- P2200NOx sensor, bank 1: circuit faultPlan a garage visit
This page is an indication, not safety advice. Symbols, colours and the meaning differ per make and model: always check the owner's manual of your car. When in doubt, contact a garage or roadside assistance.
Content checked on 14 November 2026.