Skip to content
SearchFree account
Menu
Powertrain · Diesel, particulate filter and AdBlue

P0546Exhaust gas temperature sensor, bank 1, sensor 1: signal too high

What does it mean?

Temperature sensors in the exhaust protect the and from overheating and control the regeneration. Sensor 1 is the first temperature sensor in the exhaust, usually close to the engine or just before the . The voltage is higher than a working part can deliver. Usually that points to a broken ground or signal wire, a loose plug, a short to a supply wire or a defective part.

This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.

What you may notice

  • on
  • regeneration does not work properly
  • Sometimes less power to protect the engine

Common causes

  • Defective sensor (they suffer from the heat)
  • Damaged wiring or a melted plug
  • Corroded plug from road salt

What you can check yourself

  • With a cold engine, compare the exhaust temperature in the app (if available) with the outside temperature
  • Look for melted or chafed wires along the exhaust (only when it is cold)

What to ask the garage

  • Is it the sensor or the wiring?
  • Can the sensor be removed without damaging the thread in the exhaust?

Checked on 14 November 2026

Read the codes of your own car

Put a small plug into your car and open Car-Z. You will see all stored codes with this explanation, plus live data.

All fault codes