Skip to content
SearchFree account
Menu
Powertrain · Diesel, particulate filter and AdBlue

P2453Particulate filter pressure sensor: signal out of the expected range

What does it mean?

This sensor measures the pressure before and after the , so the knows how full the filter is and when to clean it. Without a reliable value, regeneration does not work properly. Electrically the signal looks fine, but the value does not match what the expects from the other sensors. The part may be worn, dirty or slow, or there is a real problem in what it measures.

This is the general meaning of the code. Manufacturers sometimes use a code in their own way, so your garage may give a more specific explanation for your car.

What you may notice

  • or light on
  • Regeneration happens too often or not at all
  • Sometimes emergency mode

Common causes

  • Loose, cracked or melted pressure hoses
  • Hoses mixed up after a repair
  • Defective sensor
  • Loose plug or damaged wiring

What you can check yourself

  • Look at the small hoses from the filter to the sensor: are they firmly in place and undamaged?
  • With the engine off, the measured pressure difference in the app should be close to zero

What to ask the garage

  • Are the hoses connected the right way round?
  • Is the sensor itself defective?

Checked on 14 November 2026

Read the codes of your own car

Put a small plug into your car and open Car-Z. You will see all stored codes with this explanation, plus live data.

All fault codes