Red oil light while driving: stop as soon as it is safe and switch off the engine. Do not drive on until the cause is known.
What does it mean?
The red oil can means that the pressure of the engine oil has dropped below the minimum. The oil pump no longer pushes enough oil to the bearings, so metal parts can wear very quickly.
Common causes are a low oil level, a leak, a worn oil pump or a faulty pressure switch or sensor. Some cars have a separate amber light or message for a low oil level: that one asks you to top up soon, the red one asks you to stop.
If the light flickers at idle and goes out when you rev the engine, the pressure is on the edge. That needs attention too.
What can you do?
- Stop as soon as it is safe and switch off the engine.
- Wait a few minutes on level ground and check the oil level with the dipstick or the oil level menu of the car.
- Is the level low? Top up with the oil specified in your owner's manual. If the light stays on after that, or the level was fine, do not start the engine again and call roadside assistance.
- Look under the car for an oil leak.
What can Car-Z do with it?
Car-Z can read part of thisPartly. Most cars do not share the oil pressure itself over standard OBD2. Car-Z shows the oil temperature when your car provides it, and reads fault codes of the oil pressure sensor or switch (P0520 to P0524).
Related fault codes
These codes are stored by the car when it finds the fault behind this light, as far as the car reports them over OBD2.
This page is an indication, not safety advice. Symbols, colours and the meaning differ per make and model: always check the owner's manual of your car. When in doubt, contact a garage or roadside assistance.
Content checked on 14 November 2026.